JAY PARTS Bearing Clamp Steering JP0066 + Reinforcement for Steering Stem - Polaris

POLARIS Scrambler 850/1000, Sportsman 850/1000
Please check Model/Year!

Simply ingenious is the combination of JAY PARTS of stable aluminum bearing clamp incl. special bushing made of a highly abrasion-resistant and self-lubricating plastic with a spiral groove. Thus, the grease is optimally distributed over the grease nipple on the entire bearing surface and the penetration of water and dust is prevented.

As an optimization and reinforcement of the bulkhead (aluminum steering head), we have combined the bearing bush with the steel reinforcement (4-fold bolting possible). Thus, it distributes the pressure in case of excessive load (camber) on 5 times the surface and minimizes an expensive consequential damage.

IMPORTANT
If the bearing surface of the steering column is already worn (metal abrasion present), even our system will not bring any improvement. In this case we also recommend a new steering column.
In the combination we recommend the Jay Parts STEERING COLUMN PERFORMANCE with the part number JP0064

FEATURES
- Made in Europe
- Aluminum bearing clamp
- Highly abrasion resistant and self-lubricating plastic bushing
- Lubrication possible
- Steel reinforcement 4-fold bolting possible
- minimized wear
- increased stability and safety
- Best possible material and ideas composition

California Proposition 65 Warning
WARNING: This product may contain a chemical known to the State of California to cause cancer or birth defects or other reproductive harm.

Instruction

Installation Instruction for JAY PARTS Bearing Clamp Steering + Reinforcement for Steering Stem POLARIS SPORTSMAN & SCRAMBLER

We recommend professional installation in a specialist workshop!

To install the grease nipple from the front into the bulkhead drill a 5mm hole. The supplied grease nipple has a self-tapping thread (no thread cutting necessary).
Be careful not to damage any cables when drilling.
Place a cloth under the drilling area to catch the drilling chips.

IMPORTANT
Due to the 4-fold screw connection, the reinforcing plate has the effect that the pressure exerted on the screw connection of the clamp (be

aring block) is distributed over the 5-fold and much more stable surface, thus protecting against expensive consequential damage caused by falling. To drill the 2 additional 5mm holes, you will need to remove the front fairing and air filter box.

Be careful not to damage any cables when drilling. Place a cloth under the drill site to catch the drill chips.

Torque M8 screws: 25 NM
Torque M5 screws: 7 NM

If your steering column should have such running-in traces as in the photo on the right, we recommend a new steering column, e.g.: JAY PARTS steering column Performance JP0064. This is specially designed for the application.

IMPORTANT
If the bearing surface of the steering column is already closed (metal abrasion present), even our system does not bring any improvement, in this case we also recommend a new steering column.

RECOMMENDATION
Use only Waterproof Grease for lubrication.

Warranty & Returns

JAY PARTS BEARING CLAMP STEERING LIMITED WARRANTY STATEMENT

JAY PARTS USA Inc. offers products from premium manufactures and we strive to provide our customers with the best service and warranty.
Please note: All products are warrantied to the original purchaser only.

Be sure to inspect your packages for any damage at time of delivery.

Please check out the details of our Warranty Policy and our warranty claims process before sending a claim to us.

Contact us and we will reply as soon as Possible!

Bearing Clamp Steering + Reinforcement for Steering Stem JP0066 - Polaris